NSK manufacture a full range of deep groove ball bearings. These bearings are the most common type and are used in a wide variety of applications.
The NSK range of angular contact ball bearings has been designed to meet the increasingly demanding requirements of original equipment manufacturers. These bearings have a contact angle so that they can sustain significant axial loads in one direction together with radial loads. Furthermore, since an axial component is generated when a radial load is applied, these bearings are generally used in pairs, triplex sets, quadruplex sets, or multiplex sets. NSK offers one of the most comprehensive ranges of angular contact ball bearings available.
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads. However, depending on the surrounding structure, such an angle may not be possible.
Thrust ball bearings are classified into those with flat seats or aligning seats depending on the shape of the outer ring seat (housing washer). They can sustain axial loads but no radial loads. For Single-Direction Thrust Ball Bearings, pressed steel cages and machined brass cages are usually used The cages in Double- Direction Thrust Ball Bearings are the same as those in Single-Direction Thrust Ball Bearings of the same diameter series.
Extremely thin-section ball bearings and roller bearings contributing to downsizing, weight saving, and reduction of torque loss of robots, construction equipments, and industrial machinery.